Create repeatable top-down shots for food, product, craft, and tutorial content with a rigid arm that stays out of frame. The clamp-based setup works on most studio desks without drilling.
Working specifications
| Working load | Up to 4.5 kg / 9.9 lb, center load |
|---|---|
| VESA hole spacing | 75 × 75 mm and 100 × 100 mm accessory plate |
| Compatible sizes | Cameras, phones, compact lights, microphones, and small monitors; desk thickness 10–60 mm |
| Reach / height | Approx. 850 mm reach; approx. 900 mm working height above the desk |
| Material | Anodized aluminum arms with steel clamp hardware and rubber contact pads |
| Net weight | Approx. 3.2 kg |
| Package dimensions | Approx. 78 × 29 × 12 cm |
| Installation | Clamp to the rear or side edge of the desk, tighten the hand knob, then install the arm and platform |
Included accessories
- Articulating overhead arm
- Desk clamp
- Camera platform with 1/4-20 mounting screw
- 75 × 75 / 100 × 100 mm accessory plate
- Cable clips and hex key
- Printed setup guide
Best for: overhead product demos, recipe videos, unboxing, livestream workstations, and stop-motion setups.
Load limits are working recommendations for the listed configuration. Confirm the final production specification before purchase.
